What to do in this case, we will tell in our article.
It often happens that after pasting on the wallpaper small ( and sometimes quite large) bubbles may appear. They may well occur immediately , or a little later , immediately after drying and glue , and the wallpaper itself. In the first case , you should not worry. Most wallpaper ( especially thin ones) may not completely smooth out dries But , if enough time has passed , the wallpaper is already completely dry , and the bubbles on them have not disappeared , then the situation will have to be corrected. This can be done in various ways. But , first of all , you need to find out for yourself the main reasons due to which these bubbles actually could appear.
Bubbles on wallpaper. Why do they appear after sticking? Main reasons
- It is possible that the glue you got is of poor quality , or it does not fit your type of wallpaper. So , for example , in its density, the glue may not match the wallpaper. It also happens that you bought the glue that you need , but prepared it incorrectly , that is, not according to the instructions. If you have bubbles on non-woven wallpaper , then it is quite possible that the gluing was done incorrectly. When sticking this type of wallpaper , you should not apply glue too intensively , both on the wallpaper itself and on the walls.
- Glue on any type of wallpaper , you need to apply only evenly. If you smeared the wallpaper with glue , to glue it until it dries. If they are kept for a long time with smeared glue , and not glued , then often the wallpaper just swells a lot. Later , of course , they still dry on the wall. But , in this case, the paper shrinks a lot , displacing the air , , we again get bubbles.
- Elementary drafts in the room , during the wallpapering procedure , can also “inflate” your wallpaper on the wall.
How to remove such bubbles?
If the wallpaper has already dried up , and the bubbles on them have not disappeared , then you will need a medical syringe. It will need to be filled with wallpaper glue. Where a bubble has formed , the wallpaper is carefully cut ( cut should be very small), the air is released , and a needle is inserted there. Then , slowly , glue is poured into the syringe , and then this area is smoothed with a soft cloth.